SniveTroll Posted November 6, 2012 Report Share Posted November 6, 2012 -introduction.reichard racing use to make Vintage 2v intakes. these cost 1400 new. i scored mine for 700. i have since ported it.i have added a 1in spacer. i have a round BBK 75mm throttle body. this brings me to today. i did the Cylinder #8 to cross-over mod. i have drilled a 9/16 hole. i then tapped it for a 3/8 NPT thread for a 90* street elbow and 3/8 to 1/4 barb.installed street elbow fittings and heater hose crossover. the blue heater hose is what reichard racing used on these intakes. i used 5/16 thick fuel hose for the #8 fitting.thank you for viewing. Link to comment Share on other sites More sharing options...
Det_Riot Posted November 6, 2012 Report Share Posted November 6, 2012 This thing is SAWEEET!!! well done Jas, And fly me out there, i'll pull your intake for you! Link to comment Share on other sites More sharing options...
SniveTroll Posted November 6, 2012 Author Report Share Posted November 6, 2012 i already pulled it lol. took me an hour. Link to comment Share on other sites More sharing options...
Det_Riot Posted November 6, 2012 Report Share Posted November 6, 2012 haha bumm, so is this intake basically top of the line for a mod? Link to comment Share on other sites More sharing options...
SniveTroll Posted November 6, 2012 Author Report Share Posted November 6, 2012 No, the edelbrock currently is. I kept this because of the short runners and fuel rails. I think it came out in 2000. It was useless until high rpms but coupled with supercharer it shines.Sent by smoke signals Link to comment Share on other sites More sharing options...
RockinHrse_98 Posted November 8, 2012 Report Share Posted November 8, 2012 That thing is bad! Never seen one before. Craigslist score? Link to comment Share on other sites More sharing options...
SniveTroll Posted November 8, 2012 Author Report Share Posted November 8, 2012 i scored it on another forum. right before the recession i got it for 700. Link to comment Share on other sites More sharing options...
