Det_Riot Posted May 28, 2013 Report Share Posted May 28, 2013 While swapping my trans, Donovan and I found that one of my upper control arm bolts were loose. Tightened it back down and it was cool but I'm pretty sure it started backing out again as I heard the same knocky clunky noise. I have HPM Megabyte jr upper control arms with the heim joint on the bodyside. I need someone to get the measurement from inner flange to inner flange of the body side upper control arm bolt. As it loosened, it felt as though the spacers were sloppy so I want to cut some new ones to fit and not have to worry about them again (I think this also is a source of my wheel hop issues at the track) Link to comment Share on other sites More sharing options...
wmfateam Posted May 28, 2013 Report Share Posted May 28, 2013 Poop, I was just under my car yesterday! If no one gets it by tonight, i will measure mine. Link to comment Share on other sites More sharing options...
Det_Riot Posted May 28, 2013 Author Report Share Posted May 28, 2013 Cool thanks! If you have a caliper, just take the caliper measurement of inside to inside Link to comment Share on other sites More sharing options...
wmfateam Posted May 28, 2013 Report Share Posted May 28, 2013 Raja Link to comment Share on other sites More sharing options...
Steve-Oh Posted May 28, 2013 Report Share Posted May 28, 2013 I came up with 2.45"Sent from Space Link to comment Share on other sites More sharing options...
Det_Riot Posted May 28, 2013 Author Report Share Posted May 28, 2013 From inside to inside? WM if you wanna still grab it later for secondary confirmation I'd appreciate it! Link to comment Share on other sites More sharing options...
Steve-Oh Posted May 28, 2013 Report Share Posted May 28, 2013 I didn't really understand where you were asking to measure but this is where I thought you meant :cell: Link to comment Share on other sites More sharing options...
Det_Riot Posted May 28, 2013 Author Report Share Posted May 28, 2013 Yes sire that is exactly what I needed! Link to comment Share on other sites More sharing options...
