kucklehead Posted February 13, 2013 Report Share Posted February 13, 2013 Whos running one and im looking for one that will clear my gt40 intake with a 1"spacerWarning : TO MUCH AWESOME Link to comment Share on other sites More sharing options...
revhead347 Posted February 13, 2013 Report Share Posted February 13, 2013 I honestly don't have a picture of the strut tower brace on the car. I run a Steeda one, but most of the aftermarket ones will clear. They all have the bar coming in front of the intake. I had a Systemax 2 with a 1 1/2" spacer and it cleared fine.Kurt Link to comment Share on other sites More sharing options...
kucklehead Posted February 13, 2013 Author Report Share Posted February 13, 2013 K i was lookin at the bbk one but ill check out the steeda pricesWarning : TO MUCH AWESOME Link to comment Share on other sites More sharing options...
95opal Posted February 19, 2013 Report Share Posted February 19, 2013 Ran the same as revhead steeda for a 351 cleared both my tfs and holley both with 3/8 spacers. Link to comment Share on other sites More sharing options...
smallblocksn95 Posted February 19, 2013 Report Share Posted February 19, 2013 Mine has an original svo/frpp brace made for the 94-95 cobra Link to comment Share on other sites More sharing options...
Blackmage Posted February 19, 2013 Report Share Posted February 19, 2013 im running the FRPP cobra stb on my 96 GT, i took it off when i relocated my coil packs, and havnt noticed a difference since ive had it off... Link to comment Share on other sites More sharing options...
Prokiller Posted February 19, 2013 Report Share Posted February 19, 2013 rocking the BBK one myself. clears edelbrock RPM w/ 1" spacer fine. i will say it's really close by the throttle body though. Link to comment Share on other sites More sharing options...
Rolocut Posted September 29, 2013 Report Share Posted September 29, 2013 Whos running one and im looking for one that will clear my gt40 intake with a 1"spacerWarning : TO MUCH AWESOMEI have a strut tower brace new never installed On going project, 94 cobra, r block, tfsr225, hp efi, vortech ysInstagram [MENTION=584]Rolocut[/MENTION]Sent from my iPhone using Tapatalk Link to comment Share on other sites More sharing options...
ttocs Posted September 29, 2013 Report Share Posted September 29, 2013 I am running a cobra intake with a 3/8" spacer to clear my trickflow heads. Steeda would not clear the drivers side back portion of the intake. I think the BBK has an extra bend in it to clear that spot but I have never tried it out to be sure. Link to comment Share on other sites More sharing options...
